Skip to content
ATLAS What will my project cost?
FREN

Free calculator, no sign-up

Shingle calculator

Measure the footprint on the ground and enter the pitch. ATLAS works out the true roof area and counts the bundles.

Step 1 of 3 The area

What is the footprint?

Measure the building as seen from above. ATLAS will adjust the area for the roof pitch.

Footprint length
ft
in
Footprint width
ft
in

What is the roof pitch?

It’s read as inches of rise per foot of run.

Quantities are free here, forever. Retailer and regional pricing, grants and export are waiting for you in the paid plans.

See the plans

Good to know

What to check

Why measuring on the ground is enough

  • A sloped roof covers more surface than its footprint on the ground. The ratio is calculated from the pitch, expressed in inches of rise per foot of run. A 6/12 pitch — the most common in Quebec residential construction — adds about 12% of surface area. A 12/12 pitch, at 45°, adds 41%. So you don’t have to climb onto the roof to get an accurate figure.

Squares, bundles and nails

  • A “square” covers 100 sq ft. With architectural shingles, three bundles make a square. ATLAS adds 10% for cuts, valleys and edges. Count on about 320 nails per square at four nails per shingle, the Code minimum — more in very windy areas, where manufacturers call for six nails per shingle. Starter and ridge shingles are calculated separately, by the linear foot.

What the Quebec Code requires

  • An ice-dam protection membrane starts at the roof edge, extends at least 900 mm up the slope and must extend at least 300 mm past the inside face of the exterior wall. It is neither optional nor a manufacturer’s recommendation: it is a requirement of the Quebec Construction Code, and it’s the first thing an inspector looks at. The Code exempts only roofs of 8/12 and steeper, overhangs of more than 900 mm, unheated garages and shelters, and “low-slope” installation, which has its own rules.

The other free calculators